In these anchors with a long threaded span are two wings tilted with a spring. After folding them along the stem, the anchor is inserted into a drilled hole in the ceiling made of plasterboard. After staring through the hole, the wings spread on the bottom of the plate tilted with the spring. Now all you have to do is tighten the pin ended with an eye or hook, to get a hook, e.g.. for suspension of the chandelier, lamps or other suspended elements.
Dremel Multi
Many work performed at home includes small work on various types of small items. Typical power tools may not be useful. Dremel Multi will be a great tool for this. Well, a set of accessories is attached to the electrically powered small power unit (frezy, brushes, drills etc.) counting over 100 pieces and enabling all work in wood and metal. This electronic tool is particularly useful in all kinds of renovation works.
Mini -line
A small soldering iron can be easily made of a larger one, Mounting a short section of copper wire on her cave 3-4 mm. The end of this wire will create a new grotto, enabling soldering small parts, e.g.. wires. However, we must be careful in such a soldering iron, in order not to heat up a new tip for too long, because it may be overheated. That the new tip would not break off, We need to wind the wire 5-8 ganglings for the old grotto.
Strip fastening
When building partition walls or installation walls, you must first assemble the grate from wooden tongues. The grate consists of vertical posts reinforced with horizontal crossbars. Most often, the crossbars are located the form of crossing, And this makes it difficult to drive a nail. However, if we set the bar vertically and move from the axis, it can be easily nailed with nails stuck in the sides of the posts and the forehead.
Safe hammer
When hammer nail hammer into the surfaces of wooden furniture finished with veneers and varnishes, there is a danger of damage to their hammer hammer in the last phase of the nail head. This protection may be a regular rubber or soft plastic pad with a hole, Slipped to the still protruding nail. The hammer's hammer will hit the pad in the event of a nail head, not in the surface of the furniture.
Metal detector
Before many drilling in the walls, ceilings and floors should check the course of electrical and water wires, In order not to damage them during drilling. In the case of electrical ones, this may face paralysis. For detection, it is best to use an electronic metal detector available in many versions in tool stores. The light or sound signal sliding on the wall will signal the location of the cable inside the wall under the plaster very carefully.
Climbing pliers
Sometimes in assembly works, Very often we have to holes up pliers or pliers and tighten them on objects. It is tiring for your hand. Using pliers, We will significantly improve, If we provide their automatic opening after the tightening. We will get it by sliding a piece of a rigid rubber or vinidure tube on both handles. After bending, it will quickly go back to the previous shape, swinging the pliers to the needed size.