Fastening of the frames.
When replacing windows and doors, that it is not enough to attach them only with mounting polyurethane foam. Mechanical attachments are also necessary, eliminating the door frame, e.g.. with very strong winds. They are mechanically attached in two ways. If the wall is plastered, It is used for long expansion, Anchors inserted through the frames into the holes drilled in and in it. When the wall is uninterpreted, it is better to use tin anchors screwed to the bottom of the frame and wall.
Side wall
One of the novelties on our market in the field of bathroom equipping is a single side wall for a shower cubicle, production of Sanitec Koło. It can be made of tempered glass or acrylic. It can be connected with a typical square cabin during assembly, half -round or pentagonal. Thanks to it, such a built -up shower cabin can be set anywhere by the wall. Without it, the shower cabin can only be set in the corner of the bathroom walls, which is not always optimal in bathrooms.
Tilt anchors
For fixing and suspending objects on the ceilings of all kinds, in which empty spaces occur, tilt anchors can be used. The body of this wing -shaped anchor slides into the drilled hole, and then hooks on the bottom of the plate by pulling the cable. With a stretched cord, a hook screw is also screwed into the anchor body, pressing the whole to the bottom of the hole, and then cuts the cord. This kind of anchor is especially recommended for suspended ceilings from various types of plates.
Renewal
The bane of our ceramic wall and floor cladding is the dirt between the tiles. Mineral welds absorb moisture easier, and this favors the development of algae and mold. The welds can be renewed by washing them with a sponge with water with the addition of dishwashing liquid. Then, using a small weld brush, smear the Kreisel Frische Fuga preparation. The preparation is intended primarily for bright and very light joints, because the effectiveness is best seen on them.
Injection anchors
Injection anchors are intended for anchoring and hanging various objects on the walls made of ceramic materials with internal air emptiness. The mesh body of this anchor slides into the drilled hole. After removing the plug protecting the thread into the body, a two -component injection material is injected.. After freezing and removing by the poles, you can screw the screw with a pendant into a jammed anchor or screw the object, e.g.. wooden patch or metal profile.
Span
When putting down the walls and ceilings, both cement and gypsum putty, The operation will be facilitated by storing in a flexible half of the rubber ball or plastic. From such a container it will be easy to get it with a spatula, in the amount needed. More importantly – It will be easy to crush the dried residues after finishing work and wash the container thoroughly. Also during work, we can easily wash the container and prepare a new portion of putty in it.
Filigran -type ceilings
To all buildings, in which we care about greater strength of ceilings with large spanities, the so -called. Filigran -type ceilings. These are concrete slabs with a small several -centimeter thick reinforced with longitudinal spatial trusses. After the right plate setting on the wall and the appropriate support, they are poured with a thicker layer of concrete. Nadbeton. After the concrete is tied up – endurance.