Direct to the wing hinges with screws to all kinds of chipboard doors does not make much sense. Already after short -term use, the connection relaxes enough, that the screws fall out themselves. Only permanent attachment will be obtained by introducing screws, that their flocks pass through hard, solid wood, in which they will stick strongly. Therefore, on the side edge of the plate, it should be drilled with three holes and pasteing typical hard wood furniture pegs into them.
Tape hinge
Less often used, But the tape hinge is really good. It is generally mounted to the larger doors, with a significant weight. This hinge is screwed to the side of the element. He fulfilled his role perfectly, when it was screwed to solid wood elements. If it is screwed to the sides of the elements made of wood -like plates, and especially from chipboard, the only permanent fixation will be obtained by screwing the screws fastening the hinge not in the plate, but in previously pasted wooden connecting pins.
Equal length
When cutting a large number of slats. It is better to use easy to make easy to make quick workmanship. It is enough to nail a resistance block on the working table or a piece of plate, with a perpendicular forehead, after which the saw blade will be conducted. At the right distance from the block we stick the nail. Now we put the slat to the block and slide it down to the nail, then cut.
Nail setting
When hammer nail hammer into the surfaces of wooden furniture finished with veneers and varnishes, there is a danger of damage to their hammer hammer in the last phase of the nail head. This protection may be a regular rubber or soft plastic pad with a hole, Slipped to the still protruding nail. The hammer's hammer will hit the pad in the event of a nail head, not in the surface of the furniture.
Division of width
With many routes, it is necessary to divide a dimension, e.g.. the width of the board for several equal sections. It is often not easy, Because how to divide and mark the dimension with a pencil 11 cm for four episodes. But just screw the scoop oblique, that it indicates from side to side the number of centimeters well divided by four e.g.. 12 cm. Now it is easy to select the dividing points and delete the lines parallel to the side. We will receive a very accurate division of width.
Mounting hinges
A side hole is needed to mount the stake hinge on the side and furniture door., crossing the main hole, through which we screw the pin hinged pin with a screw. So it requires thorough drilling of both holes. We get the required accuracy, If we use the device when drilling this side opening. It must be slipped into the previously drilled main hole, and drill the side opening through the pilot hole.