We can easily enclose a bathtub or paddling pool with different dimensions with a cellular concrete tiles. Thanks to the large tiles dimensions 20×60 cm to a minimum we limit their number, as well as the number of joints. At the tub housing, place the tile vertically around the bathtub and stick with thin -layer adhesive mortar. After tieing the mortar, the external facing surface should be sanded, prime, and then glue ceramic tiles.
WANNA FUNCTION SEATING
To seal the bath of the bathtub with a wall finished with ceramic tiles, we can use a special plastic bath profile. We paste his one arm under the wall tiles as in the case of other typical plastic profiles. Horizontal, The slightly sloping second arm of the profile after removing the protective belt should be glued to the edge of the bathtub. This flexible profile easily transfers any vibrations, while ensuring the necessary tightness.
Switching bell of the cistern
In modern circuits for toilet bowls you can, by moving the knob and pressing the appropriate element, set the bell to different amounts of water flowing out – 3 the 6 l albo 3 the 9 l, depending on the needs. This saves a large amount of it. This type of flushing devices are installed in all modern toilet bowls of various companies, both in hanging bowls, standing and compact.
Sewage outflow
In many cases, it is difficult to freely arrange sanitary devices with sewage outflows. These must be discharged with wires to the sewage departments located nearby. However, special pump devices can be installed, which sewage gathering in the tank, they will pump periodically to the collective installation, located even far from the device or situated in a little available place. This solution allows in many cases the optimal bathroom device.
Valves – krosce
Connecting all types of wall batteries from the pipes of cold and hot water installations occurs with the help of connecting connectors, wounded at the ends of the pipes. In modern solutions, such connectors are equipped with small ball valves, closed and opened with a flat screwdriver blade. This allows you to easily and quickly close the water supply to the battery when dismantling it, Without the need to close its tributary for the whole apartment.
Cutting thin -walled tube
The metal thin -walled tube will be easily cut with any metal ball, If we slide a wooden disc with a selected diameter into its interior and we cut the tube with it with it. However, In order for the cutting to be properly and efficiently, the diameter of the wooden rod cannot be less than 1 mm from the inner diameter of the tube. The tube cut in this way can be attached in a vice with wooden prismatic jaws.
Unscrewing the siphon with slats
To unscrew siphon lids, and other plastic elements with large diameters, We can use two wooden slats, related at one end. By covering the cover they will create a key type, which cover will unscrew without damage. Slats with a cross -section of 1.5×3 cm should be around 50 cm. This will allow the siphon with a typical diameter. The larger the siphon, the greater the length of the slats.