Correct, The vertical moisture of the foundation or basement walls of the light type should be made of three bituminous layers of asphalt-stone masses. Earlier, we have to apply a cement mortar clipping on the wall with the addition of contact emulsion. We rub the reinforcement with a smooth steel trowel, and before applying the first bituminous layer, we prime with the appropriate preparation.
Panel for the shower tray
Half -round paddling pools can be shielded with acrylic panels fastened with the floor between the floor, and the upper edge of the shower tray. This eliminates the need for their housing with ceramic elements and finishing with ceramic wall tiles. Many types of acrylic bathtubs of this company are covered in the same way. The panel is easily removed, to get under the bottom of the paddling pool, and also mount it again.
Automatic ventilator
Modern PVC Wood Tuba windows are already equipped with an automatic ventilator mounted in the upper, horizontal frame. The ventilator is a special membrane mounted on the gap. In the event of a humidity increase in the membrane apartment, and thus enabling the ventilation of the room. When the humidity falls, the membrane straightens the gap. In such windows, the function of unsealing is no longer required by turning the handle.
Checking if the glue has dried
When gluing with contact adhesives applied to both surfaces, The glued parts can be connected only after the initial evaporation of the solvent from the glue. It's best to check it with your finger. Should not stick to the glue layer. The applied finger is lightly pressed to the glue layer and carefully tear off watching that the thin threads of glue are stretching. With the adequate adhesive, the finger will leave a poor trace on the surface.
External transfer
Most of the ceramic washbasins used so far had transfers directly made in the body. This solution is not beneficial for hygiene reasons, because it promotes the development of bacteria inside the transfer. In new constructions, It is used for the washbasins of external transfers, made of plastic. Transfers are attached to the stroke under the sink. Equipped with a closing plug controlled by a battery button as in other solutions.
Thin -layer pull plasters
Thin -layer drawn plaster is a mineral mass, in which there are aggregate grains of different sizes. Such plaster is applied with plastering trowel on the wall with a layer of several millimeters thick. When rubbing on this plaster smoothly with a steel plaster, the grains contained in the mass are moved, Thus creating the so -called. bark beetle texture – that is,, which this pest leaves when feeding under the bark of trees.
Tight contact of the bathtub with a wall
For hot tubs, available on the web, You can buy a special system of sealing profiles with a wall lined with ceramic tiles. Together with shapes and plugs, they give a practical and aesthetic finish, protecting against the water penetration for the bathtub both from above and from the sides. These profiles are glued directly to the wall lined with ceramic tiles.
Silicone pocket joint joint
Frapping the gaps with silicone kit will greatly facilitate sticking along the gap of two adhesive tape strips. After applying the putty and its alignment, they are broken off. The thoroughly equal edges of the pit in the weld remain exactly. This method must always be used when jointing cladding made of ungrointed tiles. Silicone can grassy it, and dirt cannot be removed with chemical preparations.