With manual longituding of all slats, boards and even plates may occur phenomenon. To eliminate this, we must slide a thin wooden wedge in the gap, which will broaden the rude. We move this wedge as it cut like this, that it would always be 50 cm from Piła. However, remember, that the wedge cannot push the gaps too much, because it threatens to split a cut board, especially in the last stage of cutting.
Sharpener
Sharpening of each hand saw begins with a fabric of the tooth vertices with a fiber, so as to level their height. Only after this is the drums between the teeth and sharpening them. For sawing vertices, we must remove the handle from the file and move it flat along the tooth lines. The work will be much easier in this case to place the file in a special wood device. The file is clinic in the instrument, which we draw to the side of the saw and by pressing such a set from above, we stip the vertices, and then we shape them and sharpen them.
Exact cutting
Fitting all wooden parts depends primarily on the accuracy of their implementation. Therefore, we never run the marked scratch when cutting the saw; We always cut next to it from the side of future waste. When some turns out to be slightly longer, We can always match it with a file or by sanding with sandpaper. Cutting at the marked line, and not after it allows you to constantly control the correctness of the cut. With a little practice, we will be able to lead the blade at a distance 0,5 mm from the line.
Glue closing
When you work for a long time with carpentry adhesive, both aquatic, and solvent, It dries in a dish, dries on the edge of the vessel and the brush. To prevent this, It is worth making a hole in the lid and a brush through it. When lubricating, the lid will not disturb too much, and after putting the brush into the can, The lid will close them, preventing adhesive. The lid must be attached to the handle in such a place, so that the brush is immersed in the glue only part of the bristles.
Grille in the window
We generally protect many of our windows or balconies with steel bars. However, hardly anyone knows, that the grille is made of round rods with a diameter 8-10 mm, Most often it is not worth the arms bars. Well, you can easily cut the bars with hydraulic shears. It will be much more difficult, When we set the grille from flat bars situated by cross -section. Also cutting a handball will be more difficult than a round rod. More difficult, because each grille can be cut anyway.
Chisel
When veneering the edges of the plates, both laminated rim straps and natural veneer stripes, it is necessary to cut the edges protruding for several millimeters beyond the edges of the plate. Cut this protruding edge can be sharp, wide, sliding on the surface of the plate. The accuracy of cutting is primarily determined by the most sharp chisel. When cutting natural veneers, we always run a chisel according to the direction of the jar – Never under them. The chisel moves based on the plate.
Homemade
A wooden stump is an indispensable device in the kitchen, on which you can beat the cutlets or cut the bone in the meat. It is easy to glue such a stump from wooden blocks with a square cross -section. The stump should be thick 5-8 cm. Individual glued pads should be reinforced with a stainless compound with screwed screws, strongly squeezing the whole stump. The needed blocks for the construction of a stump can be cut off from a long tontal and with an appropriate cross -section, e.g.. 6×6, 8×8 cm.