Many companies can be found in the offer, Thin plasterboard. Of them, all kinds of partition and installation walls with arc -shaped can be made. Plates are easy to bend with rays not less than 60 cm. Special steel floor profiles with cuts must also be used to build the walls, enabling a bow profile bending. Of course, the bottom profile is attached with anchors to the ground and slide in vertical posts as in the construction of standard straight walls.
Wallpapering behind the radiator
The walls behind the radiators are generally not wallpaper. Because too high surface temperature causes peeling of the wallpaper. However, if it is required for various reasons, This cutting of the glued brown into the belts will facilitate the insertion of the wallpaper for the radiator and properly pressing against the wall. Cut the wallpaper with belts width 10-15 cm. Individual belts are attached one by one, to the wall also covered with glue. However, we really wallpaper, when it is necessary.
Paneling
The old way of fixing paneling slats by nailing them with nails released obliquely in the groove should already go into oblivion. Because it is too laborious. It is more convenient to use special cufflinks. We put a clove of such a buckle into the inlet of the slat, boards or wall panel, and then the buckle is nailed or screwed to the undercoat anchored to the wall. The buckle clove in the groove does not hinder the insertion of the feather of the next strip or panel panel.
Supporting floor boards
When laying floor boards, to get the smallest possible gaps between the neighboring ones. Therefore, before nailing with nails to joists, each board should be pulled to the previously arranged, Preferably with the help of wooden wedges stuck between it and the resistance block nailed to the floorbag. Of course, we reach each legar successively. Equal boards, Two or three pieces can be drawn carefully and thoroughly.
Longitudinal connectors
Belks and edges of various dimensions in the cross -section can be combined along traditional carpentry connectors or steel connectors of various types screwed to wood with screws. Two connectors are the most commonly used, worth recommending. In the first case, two brackets are attached to the sides of the beams. When we want, To make the connection invisible, use a second type of connector mounted in deep cutouts perpendicular to both beams.
Wood bending over the steam
Thin slats can be bent without fear of their crack, having previously heated them in the cloud of a pair formed by boiling water. The slats has a larger cross -section, the longer you have to heat it. In any case, the slats should be bent gradually. Heat well and slightly bend, then heat up and bend more and more. Only when bending in large arches and rays can we heat it once.
Preventing leg unscrewing
To prevent the undesirable unscrewing of the legs in the table under the influence of vibrations, Already when installing the furniture. We can also cut such pads from a thin plastic sheet, e.g.. floor coverings made of PVC and tighten it strongly, to squeeze the pads. Their elasticity will prevent the legs from unscrewing under the influence of vibrations occurring during the use of the furniture.