When painting wood, it is important, to completely remove the resin, Especially from Sęków. It is best to do it by heating the blow with the blower and wiping the resin with a tampon wet in turpentine. We have to do it for so long, until the resin stops flowing. Then, after wiping with a cloth, it will remain clean without signs of the resin.
Rotary door
Sometimes it may be beneficial to install in the rooms of the rotary doors, e.g.. between the bedroom, A wardrobe. They can be predicted there, where high tightness and acousticness are not necessary. It is worth mounting them, because they are the easiest to make independently, even from a piece of chipboard or other wood -based. The aesthetic finish of the plate will be simple, and it is easily mounted on two rotating steps inserted into metal sleeves preferably brass.
Pins for plates
Many walls in newly put into use are made of plasterboard, fiber-gypsum or wood-based. Special plastic dowels with a larger diameter with a deeply cut thread sculpture are intended for fixing and hanging objects on these walls. It is thanks to this thread depth that after screwing the screw, the screw is strongly stuck in the walls, e.g.. installation or partitions covered with one or two layers of gypsum-card plates.
A carpentry vice
If we weld a thick steel pad for an ordinary screw compress, We will get a simple vice. The base will be able to be attached to the table, creating a stationary fastening similar to a vice. Two such instruments attached to the workshop table at the right distance from each other will allow you to attach a longer board or cut lane made of wood -based plate.
Nail scraper
Glued surfaces, np. wood, We should sinner. For this purpose, we can drag on them with a wooden block with tightened nails. There will be many scratches on the surface, and thus we will get adequate adhesion of the adhesive. This device will be very useful when preparing large flat surfaces, such as wood -based boards or wide boards.
Storage of plates
All kinds of albums: Gypsum-card or wood-based should be stored flat on the ground on boards pads. If it is impossible, It can be stored by leaning against the wall. But in this case they are set obliquely based on several boards. Without such a support, the plates will bend and pack permanently. Generally to support boards with a height 2,5 m and width 1,2 m, Five boards with a width 10-15 cm, evenly placed on the length of the plate and based at an angle 60-75 degrees.
Sheet metal connector
If we glue all kinds, You should think about strengthening such a connection. The adhesive weld itself may not withstand the load. There are many ways to strengthen. One of them is strengthening by sticking in both parts of wooden folded metal plaques. Of course stainless. The baking tray can be laid yourself and tightened one lower edge. After this, we stick the baking tray with a hammer, until it completely hides in the wood of both glued parts.