When sticking the glass nails, the hammer is moved on the glass. So as not to break it or scratch it, Let's put a piece of soft cardboard with the right dimensions under it. Stins should be stuck with a small thin glass or modeling hammer. If we get a practice, a cardboard pad will turn out to be unnecessary – The hammer will move immediately on the glass.
Croilling cutting of glasses
It seems unbelievable, But construction glass can be cut effectively with ordinary home scissors. You can cut out any of the curvilinear shapes from a larger pane. All you need is a glass plate and scissors in a larger dish filled with water. Very easy, Just like paper, We will cut a glass window with a thickness 2-2,2 mm. Large forces and strong scissors need to be used at a larger thickness window. The disadvantage of this type of cut is the complete concentration of scissors blades.
Combined glass
In modern windows, the so -called. combined glass, that is, the type of glass of glass glued together. When choosing a window, we should determine whether we require one, or a two -chamber combined glass. Single -chamber are glued with two windows, two- from three ordinary shafts separated with spacers. Thermal and acoustic insulation depends on the thickness of the glass and the distance between them. In the designation of a combined glass, e.g.. 6x12x6, numbers first, The third determine the thickness of the glass in millimeters, second – A distance between them.
Roof windows
Roof windows are intended for mounting in sloping roof slopes between the rafters. Create lighting for rooms on a developed attic. They are mounted after the roofing part is removed. They are easy to mount, e.g.. Compared to the structure of typical dormers in the roof slope. We can use various types of windows with different opening methods. The most beneficial to use are these, which opens at the bottom and tilts outside around the upper axis of rotation, and also rotates at 180 °.
Listev
For cutting, we can place a strip or a patch flat on the table, or extend it with a cut off end outside the table top. In any case, however, the strip will move during cutting. To prevent this, we must prevent it strongly or even very strongly with the hand, which is quite bothersome. We will free ourselves from this necessity, If the strip is based on the front resistance strip in the instrument with a piece of board. We get even better working conditions by nailing an additional resistance letter to the bottom of the board – device.