Special pen drills are used to drill the holes in glass, Mounted in a free -speed drill holder. Aid in drilling is a turpentine poured inside the border formed from glass putty or plasticine. The roller should form a border with a diameter of about 10 cm and height 1 cm. Inside it, we pour turpentine, a layer with a thickness of about 5 mm.
More efficient ball
With many cuts with a hand saw, the bending of the bow may be insufficient. It can happen, when we want to cut a piece of larger plate parallel to its longer side. However, the bow itself can be bent at a right angle. In any way it will not worsen the efficiency of the tool, and it will allow you to cut long. With minor work, e.g.. modeling bow is just bending at smaller than 90 angle degrees.
Dosing funnel
If we mount the plug in the ordinary funnel, We will receive a special dispensing funnel. It will be easy to close at any time, fluid flow from the funnel and open it again. The cork needs to be made thoroughly and sanded by matching the shape to the funnel cone. Drum made of long nail is stuck into the cork and pour over the upper bar. After lifting the stem with a traffic jam.
Canned paint mixer
Small and short files, conifers are most convenient to settle in a wooden handle via a regular plastic expansion pin. The inserted end of the file will break the peg and the whole. With such attachment, it will be easy to pull the file and work with it if necessary without a handle. It will also be easy to slide in the same handle – conifer with a different cross -section shape, needed for other types of work.
Fastening the conifer in the handle
Small and short files, conifers are most convenient to settle in a wooden handle via a regular plastic expansion pin. The inserted end of the file will break the peg and the whole. With such attachment, it will be easy to pull the file and work with it if necessary without a handle. It will also be easy to slide in the same handle – conifer with a different cross -section shape, needed for other types of work.
Walk tag
To accurately determine the middle of the cylinder, We can use a simple device from a piece of disc. The cutting of two crossed lines on the shoulder of the device will determine the meaning sought after. The body of this device should be cut from thin modeling plywood. We attach two short resistance flocks to the bottom of the body. However, it is important, To set both mandrels symmetrically relative to the edge of the body, at which we remove the line.
Pressing when milling
When milling. This can be obtained, Mounting a spring pressure in the guide, under which the workpiece is slid. To ensure the right pressure, choose the diameter of the wire and the bending method. The pressure should be the stronger, The larger the cutter of the milling and its length, and thus greater milling forces.
Tampon for polishing
Tampon is needed for polishing. You will need a piece of non -looming to make it, preferacted. The canvas wraps the fluff, creating a tampon needed size. Before wrapping the fluff, you need to thoroughly rinse in water with the addition of washing powder or dishwashing liquid, and then dry. The cloth in the upper part is bound by a string.
Rotary grinding brush
The interior of the pipe can be cleaned with a simple metal stem with swallowed abrasive canvas. Attached to the drill handle, It's easy to slide inside the pipe. The rotating stripes will remove rust thoroughly. We get a good tool of this type when attached to one strap on the mandrel. However, better results will be then, when we attach a few shorter stripes in the mandrel.
Template for laying stairs
Placing floor coverings on the stairs, It is better to cut the appropriate templates from cardboard or paper in advance, the shape corresponding to individual stairs. This is especially recommended for the steps of the winding and treatment stairs, in which each step has a different shape. In some cases, we arrange the liner, turning it onto the risers. In this case, the quantities must be taken into account on the template.